Installation Of Downlight - Emerson PORTLAND CF965BS00 Instructions

6.1
Remove the pre-installed wire nut from the fan motor
assembly white wire. Carefully straighten the white wire
strands. Pair the light kit assembly white wire with the
motor assembly white wire and install the previously
6.2
removed wire nut (Figure 24).
Remove the pre-installed wire nut from the fan motor
assembly black wire. Carefully straighten the black wire
strands. Pair the light kit assembly black wire with the
motor assembly black wire and install the previously
removed wire nut (Figure 24).
WARNING
!
Check to see that all connections are tight and that no
bare wire is visible at the wire connectors.
6.3
Remove one of the three #8-32 x 1-1/4" slotted phillips
head screws from the light kit cover (Figure 25). Retain the
screw for future installation. Loosen the other two screws
6.4
several turns.
Carefully tuck all the wires under the light kit assembly
prior to installing the light kit assembly onto the light kit
6.5
cover.
Install the light kit assembly onto the light kit cover by
aligning and engage the radial slots of the light kit with the
6.6
loosened screw heads on the cover.
Rotate the light kit assembly to engage the two loosened
6.7
screws.
With the light kit locked into position, tighten the two
6.8
previously loosened screws
Reinstall the #8-32 x 1-1/4" slotted phillips head screw
(previously removed) into the light kit assembly to
complete installation of the light kit.

6. Installation of Downlight

FAN MOTOR ASSEMBLY
BLACK WIRE
FAN MOTOR ASSEMBLY
WHITE WIRE
LIGHT KIT ASSEMBLY
WHITE WIRE
LIGHT KIT ASSEMBLY
Figure 24
ROTATE LIGHT KIT ASSEMBLY
CLOCKWISE TO ENGAGE
LIGHT KIT ASSEMBLY
8-32 x 1-1/4" SLOTTED
PHILLIPS HEAD SCREWS (3)
Figure 25
!
To avoid possible fire or shock, do not pinch wires
between the light kit assembly and the light kit cover.
Spare #8-32 x 1-1/4" slotted phillips head screw is
provided in parts bag if needed.
16
LIGHT KIT
ASSEMBLY
BLACK WIRE
WARNING
ETL Model No.: CF965
LIGHT KIT
COVER