Table des Matières
Publicité
LED Light Guide
LED Light with power Adapter
SKU# 60836/60838
The adapter kit is used to connect to the
electrical outlet, and contains the power on/
off switch for the LED lights. It is used when
one single light unit is needed or as the first
light used when linking multiple light units
together. It controls on/off power for all light
units linked to it. Includes adapter, LED light,
plastic clips, and double sided tape.
How to connect the LED Lights
For LED Lights to work correctly, the adapter
cable (A) must connect to end with on/off
switch, for LED Light to be operational. Use
connector cords (B) to connect additional
lights. Up to 4 LED lights can be connected
to one Power adapter cord(A).
NOTE: For Wall Switch Operation
If you are using a switch controlled power
outlet to operate the LED Lights, the power
adapter cord needs to plug into the end
opposite the ON/OFF switch end.
wire
LED Light with Connector
SKU# 60837/60839
The connector kit is used when additional light
units(up to 4) want to be linked together. It
works in conjunction with and is controlled by
the LED light with power adapter unit.Includes
double sided tape and plastic clips.
B
ON/OFF Switch
A
A
Installing LED Lights for Display Cabinets
Method 1. Using double sided tape
1
provided. Attach double sided tape to
back of LED light bar. Peel backing off.
For bottom Display cabinet drill holes on back panel following Diagram 1. The
2
hole can be placed on either side of cabinet at point A. or B., depending on outlet
location. Using installation method from Steps 2 or 5 above center and install LED
3
light 3 - 4 inches in from front.
Publicité
Table des Matières
