Table des Matières
Publicité
Mounting Cabinets
Use stud finder to locate the studs
7
and mark the wall with a pencil.
9
Near the top of the cabinet, drill 1/4" holes through the back of the cabinet that are in line with
marked studs. Repeat for drilling two holes near the bottom of the cabinet.
Pilot Holes
10
Place cabinet flush against wall and
attach using screws and washers.
8
Gather parts.
4 x Lag Screw
4 x Threaded
4 x Threaded
6mm x 55mm
Washer
Caps
11
Use threaded caps to cover screws.
Fastening Cabinets
Drill 3/32" pilot holes
12
13
Parts Needed.
on interior wall of cabinet being fastened.
4 - #8 x25mm
screws
Using pilot hole as guides, screw into second cabinet.
14
Do Not Over-tighten screws and Punch through other side!
Note:
All shelves must be removed prior
to fastening cabinets together.
X4
X4
Publicité
Table des Matières
