Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
10 electrolux
INSTALLATION
Remove all protective packaging for transit
before using for the first time. Keep in case
needed for future transit: Transporting a non-
secured appliance may damage internal
components and cause leakages and mal-
functions. The appliance can also be dam-
aged through physical contact.
Unpacking
1
3
Untying
4
1a
2a
3
2
4
1a
1b
2
1b
2b
4
To install your washing machine at the
same level as surrounding furniture, pro-
ceed as shown on picture 4.
Water supply
1
In case of necessity move the inlet hose in
the direction shown on picture no. 1. To
make this loose the inlet hose ring nut and
position the inlet hose downwards as
drawn on picture no. 1. Tighten the ring nut
back and make sure there are no leaks.
Open the water inlet tap. Check there are
no leaks. The water inlet hose can not be ex-
tended. If it is too short, please contact the
after-sales service.
Drainage
Fit the U-piece on
the drainage hose.
Place everything in a
drainage point (or in
a sink) at a height of
between 70 and 100
cm. Ensure it is posi-
tioned securely. Air
must be able to en-
ter the end of the
hose, to avoid any risk of siphoning.
The drain hose must never be stretched. If
it is too short, contact an engineer.
Electrical connection
This washing machine must only be connec-
ted in single-phased 230 V. Check the fuse
size: 13 A for 230 V. The appliance must
not be connected with an extension lead or
multi-plug adaptor. Ensure that the plug is
earthed and that it is in accordance with cur-
rent regulations.
Positioning
Position the appliance on a flat and hard sur-
face in a ventilated location. Ensure the ap-
pliance does not come into contact with the
wall or other furniture. Accurate levelling
2
Publicité
Table des Matières
