Dimplex Revillusion RLG20 EU Mode D'emploi page 10

Operation
Battery Replacement
To replace the battery:
1. Push the release tab toward the
center and slide the battery cover
open.
2. Install 3V Lithium battery in the
battery holder. The positive (+)
side of the battery faces up.
3. Close the battery cover.
OPEN
PUSH
RELEASE ---- DÉGAGER
Lithium Battery--Batterie au lithium
Battery must be recycled or
disposed of properly. Check
with your Local Authority or
Retailer for recycling advice
in your area.
General Maintenance
Inspect the log set regularly, depending
upon conditions, and at a minimum
yearly intervals. Remove dust and
clean the logs, mat, grate, and base as
required.
Except for installation and cleaning
described in this manual, an authorized
service representative should perform
any other servicing.
WARNING: Disconnect power and
allow heater to cool before attempting any
maintenance or cleaning to reduce the risk
of fire, electric shock, or injury.
10
---- OUVRIR
---- POUSSER
CR2025/2032
OPEN
RELEASE
PUSH
Clean Logs and Base
The log set should not be operated with
an accumulation of dust or dirt on or in
the unit, as this can cause a build-up of
heat and eventual damage.
Dust and vacuum the log set as
needed. Use a damp cloth and a mild
detergent to clean painted surfaces
of the fireplace. Never use abrasive
cleaners.
Clean Mirage Flame Panel
The Mirage Flame Panel is cleaned
in the factory during the assembly
operation. During shipment, installation,
handling, etc., the screen may collect
dust particles; these can be removed
by dusting lightly with a clean dry cloth.
To remove fingerprints or other marks,
clean the Mirage Flame Panel reflector
screen with a damp cloth. Never use
abrasive cleaners. Dry the screen
completely with a lint free cloth to
prevent water spots.
Temperature Cut out
Should the heater
automatic cut out will turn the whole
unit off and it will not come back on
without being reset.
It can be reset by turning the unit off at
the main supply and waiting 5 minutes
before turning the unit back on.
CAUTION:
continuously reset the heater, turn
the unit off at the main supply and call
technical support.
overheat,
If you need
GB
an
to