GBC FUSION 5100L Manuel D'utilisation page 6

GB
getting ready to laminate
Easy Set Up
1 Remove the plastic exit tray from the box and place into the two holes on the back of the
item to be removed.
2 Take the electrical plug and place in an appropriate power source, which is near the table you
intend to use.
The socket-outlet shall be installed near the equipment and shall be
easily accessible.
3
4 To use the laminator gently tap the 'power on' button.
NOTE: Your new laminator may emit
a slight odour during the initial
operation. Its is normal and will
diminish after a few hours of
operation.
Interactive Menu Selection
5 A GBC logo will show in the screen followed by the main menu:
MANUAL SELECT
SETTINGS
NOTE: Use arrows to scroll up/down and left/right, use ENTER
button to select.
Use at anytime to go back – one screen at a - time to the
main menu.
Manual Select (
NOTE: If 40mic setting is selected
ALWAYS use a carrier
6
register this product online at www.accobrands.com
AUTO POUCH SELECT
HELP
) – scroll through and select the required micron setting, i.e. 75mic.
40 mic
75 mic
125 mic
175 mic
250 mic