Electrolux EI30BM5CHZA Instructions D'installation page 5

Rotate 180˚
Change the position of wire to left side hole
(B)
Figure 9B
Hood Fan Wire
Figure 10A
Exhaust Damper
Assembly
Fan Cover Bracket
Apply Rear Cushion
after Exhaust Damper
Assembly is screwed
to wall.
Save the assembly for
future instructions.
Installation Instructions
Fan Blade Openings
Figure 9A
(A)
Figure 9C
Figure 10B
(C) VERTICAL EXHAUST:
1. Remove and save 3 screws from back edge and 3 screws
from the top center of the Fan Cover Bracket. Remove
Fan Cover Bracket by sliding it in the opposite direction
of the arrow on the Fan Cover Bracket as shown in
Figure 11.
2. Lift Hood Fan Unit carefully and slip wires out of cavity.
See Figure 12. CAUTION: Do not pull or stretch Hood Fan
Wire.
3. Rotate the Hood Fan Unit 90˚ so that the Fan Blade
Openings are facing the top of the oven. See Figure 13
(A) on page 6. Replace Hood Fan Unit into the oven.
Be careful not to pinch the lead wire between the inner
bracket and the Hood Fan Unit. Put the lead wire into
Wire Box. See Figure 13 (B) on page 6.
4. Replace the Fan Cover Bracket by sliding it into the slits
in the same direction as the arrow on the Fan Cover
Bracket. Make sure the fan blades are visible through
the top openings in the oven before proceeding.
5. Attach the Fan Cover Bracket to unit with the 3 screws
from back edge and 3 screws from the top center of
the Fan Cover Bracket, which were removed in Step 1
above. See Figure 14 on page 6. The Hood Fan Unit is
now rotated for vertical exhaust operation.
6. Attach the Exhaust Damper Assembly to the fan cover
bracket on the top of the outercase cabinet after mounting
the oven. To attach the Exhaust Damper Assembly, refer
to MOUNTING OVEN TO THE WALL, See Figure 20 on
page 7.
Hood Fan Wire
Rear Cushion
5
OUTSIDE VENTILATION
Fan Cover Bracket
Figure 11
Hood Fan Unit
Figure 12
E