Storage And Transport - Sovelor HP Serie Notice Technique

Fiche technique
SO HPV20
PLEASE NOTE: IF THE HEATER SWITCHES
en
OFF DUE TO LACK OF FUEL, TOP UP THE
it
de
es
through suitable chimney. CARRY OUT
fr
THE CHIMNEY IN ACCORDANCE WITH
CURRENT SAFETY REGULATIONS AND
nl
FOLLOW THE INSTRUCTIONS IN THE
RELEVANT SECTION OF THE MANUAL.
pt
da
The appliance stops when an anomaly occurs.
The reset button turns on with a steady red
light (PIC. 17), it means the heater needs to be
no
reset. To reset the heater, press the reset button
sv
all the way down (PIC. 18). Identify and remove
the cause that stopped the appliance (for
pl
instance, obstruction of air intake and/or outlet,
total block of the fan, etc.). Please contact an
ru
appointed service center for assistance in case
cs
it is impossible to solve the problem.
hu
Set the "I/0" button to "0" (PIC. 19). Flames
sl
extinguish and the fan keeps on working until
tr
the combustion chamber has fully cooled down.
Do not pull the plug out until the cooling
hr
lt
8. CLEANING THE FILTERS
lv
THE FILTERS MAY NEED TO BE CLEANED
DEPENDING ON THE QUALITY OF THE
et
FUEL USED.
ro
sk
8.1.1. Remove tank (A) cap.
8.1.2.
bg
8.1.3.
uk
without damaging it.
8.1.4.
bs
8.1.5. Close cap (A).
el
DEPENDING ON THE MODEL:
zh
8.2.1.
8.2.2. Remove the pipe-clamping straps (B).
8.2.3. Take out the pipes (C).
8.2.4.
spare part.
8.2.5. Put the pipes (C) back.
8.2.6. Put the pipe-clamping straps (B) back.
8.2.7.
position.
Airchaud Diffusion - 35 route de Colmar, 67600 Sélestat
SIRET : 444 448 898 00015
DEPENDING ON THE MODEL:
8.3.1. Remove the cup (A).
8.3.2.
Keep gaskets for later use.
8.3.3.
without damaging it.
8.3.4.
8.3.5. Put the glass (A) back on and
reassemble the gaskets correctly.
See the preventive maintenance schedule.

9. STORAGE AND TRANSPORT

IN ORDER TO KEEP THE HEATER IN
THE BEST POSSIBLE CONDITIONS, WE
RECOMMEND TO FOLLOW THE BELOW
PROCEDURE:
9.1. Empty the fuel by removing the drain
cap at the bottom of the tank (PIC. 24-25).
Dispose the fuel in an appropriate container
in accordance with the current safety
regulations.
9.2. To remove any residual remaining, pour
clean fuel and rinse the tank again.
9.3. Close the drain cap and the tank cap.
9.4. In order to keep the heater in the best
possible conditions, we recommend placing
it in a dry and safe place.
THERMOSTAT
In models with a thermostat connection,
remove the cap connected to the appliance
and connect the room thermostat (optional)
(SEE PIC. 26-27).
Tél. : 03 88 08 67 05
Fax : 03 88 08 67 39
contact@airchaud-diffusion.fr
www.airchaud-diffusion.fr
19