ETAS ES720.1 Consignes De Sécurité page 4

ES720.1
Requirements on the ventilation
Keep the module away from heat sources and protect it against direct exposure to the sun.
•
The free space above and behind the module must be selected so that sufficient air circulation is ensured.
•
Assembling (interconnecting) the modules
• Prior to assembling (interconnecting) or separating a module stack, the modules must be disconnected from the
supply voltage or they have to be in the standby operating mode.
Transport
• Stack and connect the modules only at the location of the startup!
Do not transport the modules at the cable of the module or any other cables.
•
Maintenance
The product is maintenance-free.
Repair
If an ETAS hardware product should require a repair, return the product to ETAS.
Cleaning the module housing
• Use a dry or lightly moistened, soft, lint-free cloth for cleaning the module housing.
• Do not user any sprays, solvents or abrasive cleaners which could damage the housing.
Ensure that no moisture enters the housing. Never spray cleaning agents directly onto the module.
•
Ambient conditions
The housing and the connectors of the module as well as the plug connectors of the cables meet the degree of
protection IP20.
Opening the module
CAUTION!
Damage to the module and loss of properties based on IP20!
Do not open or modify the module housing!
Work on the module housing may only be performed by ETAS.
Potential equalization
CAUTION!
Potential equalization in the vehicle is possible via the shield of the connecting cables of the modules!
Install the modules only at locations with the same electrical potential or isolate the modules from the installation
location.
Cabling
For detailed information about cabling, see the User's Guide of the module.
Ambient temperatures
• The use of the WLAN functionality of the ES720.1-8W and the ES720.1-16W Drive Recorder variants is intended
for indoor only.
• The operating temperature range of all variants of ES720.1 is limited when using the VGA output.
The module is suitable for use in interiors, in the passenger cell or in the trunk of vehicles. The module is not
•
suitable for installation in the engine compartment and similar environments.
ES720_SAV, Version 2, 2016-10-13
F-00K-800-060
Template: 00TE00084 V11