Uline METRO Serie Instructions De Montage page 2

For adjustable height L-desk assembly, refer
to instructions included with the adjustable
height return base.
NOTE: Count and inspect all pieces before
disposing of any carton or packing materials.
NOTE: Assemble unit on a smooth, non-marring
surface to prevent scratching.
NOTE: Tighten all bolts using 4 mm Allen
wrench.
1. Attach adjustable glides (C) to the bottom corners of
each leg frame. (See Figure 1)
Figure 1
2. Align holes on one side of modesty panel with holes
in leg frame. Insert three M6 x 45 mm bolts (E) and
tighten. Repeat on opposite side. (See Figure 2)
Figure 2
PAGE 2 OF 18
DESK ASSEMBLY
C
E
For standard desk assembly, proceed to Step 3.
For L-desk assembly, proceed to L-Desk Return
Assembly on Page 4.
3. Align two modesty panel connectors (B) with holes in
top of modesty panel. Attach using two M6 x 15 mm
bolts (F) and tighten. (See Figure 3)
NOTE: For 48 x 24" desk, only one modesty
panel connector will be attached.
B
F
4. Place desktop upside down. Align leg frame
connector (A) with holes in corner of desktop. Insert
four M6 x 15 mm bolts (F) and tighten. Repeat for
three remaining leg frame connectors. (See Figure 4)
Figure 4
Figure 3
A F
1022 IH-9778