Uline METRO Serie Instructions De Montage page 5

5. Place desktop (1) upside down. Align leg frame
connector (A) with holes in corner of desktop. Insert
four M6 x 15 mm bolts (F) and tighten. Repeat for
three remaining leg frame connectors.
(See Figure 11)
Figure 11
1
Desktop
6. Place return desktop (4) upside down. Align leg
frame connector (A) with holes in corner of return
desktop. Insert four M6 x 15 mm bolts (F) and tighten.
Repeat for remaining leg frame connector.
(See Figure 12)
Figure 12
4
Return Desktop
NOTE: For left-hand L-desk configuration, leg
frame connectors should be attached to
opposite side of return desktop.
PAGE 5 OF 18
L-DESK RETURN ASSEMBLY CONTINUED
F
A
A F
7. Using two people, carefully lift the desktop (1) over
the assembled frame and align the holes in the
frame with the holes in the leg frame connectors.
Insert four M6 x 55 mm bolts (D) through the leg
frames into the leg frame connectors (A) and
tighten. Carefully lift the return desktop (4) over the
assembled frame and align the holes in the frame
with the holes in the leg frame connectors. Insert two
M6 x 55 mm bolts (D) through the return leg frame
into the leg frame connectors and tighten.
(See Figure 13)
Figure 13
A
8. Insert three M6 x 15 mm bolts (F) through the three
modesty panel connectors (B) into the rear of the
desktop and return desktop and tighten.
(See Figure 14)
Figure 14
1
4
D
B
F
1022 IH-9778