Uberhaus 72255106 Guide De L'utilisateur page 15

Step 9
K2b
J1
K1b
K2a
C1
J
K1a
C
K1a
×2
9.1. Insert the Side Roof Panels (K1a & K1b) between the Rails (C & C1) and the Roof Holder Bars (J
& J1) which form a triangle on the sides of the shelter.
9.2. Insert the Side Roof Panels (K2a & K2b) between the Rails (C & C1) and the Roof Holder Bars (J
& J1) which form a triangle on the sides of the shelter, until they reach the Side Roof Panels (K1a &
K1b).
CAUTION:
One side of each Roof Panel is treated to provide UV protection. Make sure that the side
treated with UV protection is facing outward. This step is very important – if the roof is not
assembled as per the instructions shown, it will not be covered by the warranty.
NOTE:
The panels are covered with a plastic film to identify which side has UV protection. Once this
film is removed, it is not possible to tell which side protects against UV rays. Therefore, it is
recommended to remove the film only once the panels have been installed, one at a time.
Page
15