Installation; Mounting The Hood - Elica EPT436SS Guide D'utilisation, D'entretien Et D'installation

Install framing for hood support
• If drywall is present, mark the screw hole locations.
Remove the template.
• Cut away enough drywall to expose 2 vertical studs at
the holes location indicated by the template.
two wall studs at the bottom and upper mounting holes
installation location.
•
of the studs.
• Use cleats behind both sides of the support to secure to
wall studs.
•
Centerline of

installation

space

Mounting the hood

onto the mounting screws.
•
make sure the template is leveled and centered with the
centerline.
•
•
leveled and correctly centered by the vertical centerline.
•
distance between the screw head and the wall.
•
•
a pencil.
• Remove the hood.
•
cleats
•
•
•
Mounting Support
Connecting the ductwork
• Install ductwork, making connections in the direction of
• Push duct over the exhaust outlet.
•
tape for an airtight seal.
• Make the same connection in the wall or ceiling vent exit.
8
B
B. Duct tape over seam