Mounting The Duct Cover Bracket; Ceiling / Wall Ducting - Elica EPT436SS Guide D'utilisation, D'entretien Et D'installation

Flexible ducting:
be straight and smooth and extended as much as possible.
and other naturally vented systems.
vented systems, follow the heating equipment manufacturer's
guidelines and safety standards such as those published by

Mounting the duct cover bracket

•
•
with the centerline, as described in the followinG
drawing.
Bracket line
27 28 /
32
Mark screw holes locations in the wall.
IMPORTANT. Check to be sure that holes locations are
leveled, and correctly centered by the vertical centerline.
Install wall fastener anchors.
Drive wood screws, by hand, into the fasteners to allow an-
chors to expand. Remove screws.
Secure the bracket to the wall with wood screws and/or
fasteners.
Centerline
Desired installation height
Option B - Telescopic duct cover
Secure the bracket to the wall:
•
- centerline on the wall.
• Mark 2 screw hole locations in the wall.
•
• Install wall fastener anchors.
• Drive wood screws, by hand, into the fastener to allow
anchors to expand. Remove the screws.
• Secure the bracket to the wall with wood screws and/or
fasteners.
Ceiling ducting
If the duct will vent straight up to the ceiling:
• Use level to draw a line straight up, from the centerline on
the template to the ceiling.
•
Wall ducting
If ductwork will vent to rear:
• Use a level to draw a line straight up from the centerline
on the template.
•
indicates the bottom installation height, to the circle center
House wiring location
•
•
4 12 /
16
to wall
7
Wall
For ceiling vent ducting
Ceiling
Circle center at
12
23 /
16
marked bottom
pencil line
pencil line