Installation And Operation Of Wireless 20/40/60 Minute Timer: 99-Det02 - Lifebreath AIRIA MAX Serie Guide D'installation

Installation and Operation of Wireless 20/40/60 Minute Timer: 99-DET02

The Timers may be installed onto a flush mounted electrical
switch box or it may be surface mounted onto a wall.
Multiple Timers may be installed in a ventilation system. To
increase the range of a wireless Timer, a RX02 Repeater
should be used.
Pairing:
1. Turn on the main wall control by pressing the ON/OFF
button and remove the battery from Timer.
2. Press the left and right buttons simultaneously on the
main wall control (
will go blank and the wireless symbol
flashing on the bottom right of the display. This
indicates that the main control is now in pairing mode.
(Figure D)
3. Keep the Timer within 16" of the main wall control when
pairing.
4. Install the battery in the DET02 Timer. All four lights
on the Timer will immediately flash 5 times, then only
the red battery light will remain on for approximately 12
seconds after which the "40" light flashes the rev code.
20, 40, 60 lights will flash until paired or will stop if not
paired within 12 seconds. If pairing was not successful
you now must return to step 1 to restart the pairing
process.
5. Press the button on the main wall control to exit
pairing mode when Timers have been successfully
paired.
To pair additional DET02 Timers with the same wall control,
or if pairing was not successful, repeat steps 1-5.
When paired, the DET02 Timers can be moved and installed
elsewhere. Estimated range of the Timer is 40' with no
obstructions. A RX02 Repeater may be installed to increase
the range of the Timers.
Test if pairing was successful by pressing the Select Button
and listen for the HRV / ERV to initiate HIGH fan speed
Ventilation.
Un-pairing:
1. Remove the battery from the back of the DET02 Timer
2. Press and hold the Select Button on the front of the Timer
3. While holding the Select Button, reinsert the battery in the Timer. Continue holding the
select button until the LED under "40" begins flashing. The DET02 Timer will now be
unpaired with the main wall control.
Installation:
1. Separate the face plate from the back plate by firmly pulling apart (Figure A).
2. For mounting the control without a Decora plate, break off top and bottom tabs and
refer to Figure C for mounting.
3. Place the back plate of the control in the desired location on the wall and pencil mark the
top and bottom screw holes (Figure B or C). Drill two 1/8" holes.
4. Attach the back plate to the wall using the 2 supplied screws and anchors.
5. Attach the face plate to the back plate (Figure A).
and RESET buttons). The screen
will appear
NOTE
The wireless Timers and Repeaters must be matched
to the main wall control of the HRV / ERV.
process is called "Pairing".
Repeaters can be paired to a single wall control.
Figure A
Back Plate
Face Plate
Alternate Wall Mount Figure C
Break off tab
1/8 in hole for
screw and anchor
1/8 in
hole for
screw and
anchor
Break off tab
Multiple Timers and
1/8 in hole for
screw and
anchor
1/8 in hole
for screw and
anchor
Figure B
Press Simultaneously
to Initiate Pairing
Figure D
Mode
Figure E
DET02 Timer
Removable
Backplate
20/40/60 Minute
Status Lights
Select Button initiates
high speed ventilation
for 20, 40 or 60 min.
Battery Indicator
17
This