Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Output a Burst Waveform
You can configure the instrument to output a waveform with for a specified number of cycles, called a burst. You can
control the amount of time that elapses between bursts with the internal timer or the signal level on the front panel
Ext Trig connector. For this example, you will output a three-cycle sine wave with a 20 ms burst period.
1. Select the function and amplitude for the burst.
For burst waveforms, you can select sine, square, ramp, pulse, arbitrary waveforms, triangle, or PRBS. Noise is
allowed only in the "gated" burst mode and DC is not allowed. For this example, select a sine wave with an amplitude
of 5 Vpp.
Keysight EDU33210 Series User's Guide
65
Publicité
Table des Matières
