SMA Solar Technology BEAM-AW15 Mode D'emploi page 28

Installation of the external Antenna Kit
7. Take the antenna extension cable and attach
the sealing ring to the rubber ring as shown in
the figure on the right. Ensure that the rubber
ring is in the centre of the thick part of the
cable.
8. Attach the threaded sleeve to the sealing ring
as shown in the figure.
9. Insert the end of the cable with the
internal thread through the opening of
the PG screw fitting on the inverter
housing.
10. Insert the threaded sleeve with the
sealing ring into the PG screw fitting,
rotating it slightly until the catch of the
sealing ring locks into place in the
recesses.
11. Attach the threaded sleeve to the PG
screw fitting on the inverter housing.
12. Connect the end of the antenna cable in the inverter to the antenna connection on the Radio
Piggy-Back.
28 BEAMAW-BXX073022
End of antenna
with internal thread
Sealing ring
Rubber ring
Threaded sleeve
Sealing ring
Threaded sleeve
with sealing ring
SMA Solar Technology AG
PG screw fitting