Installation For Initial Situation (B) - SMA Solar Technology BEAM-AW15 Mode D'emploi

Installation of the external Antenna Kit

1.2 Installation for initial Situation (B)

This section refers solely to initial situation (B). If the Radio Pigy-Back has already been installed at
the factory, the external antenna kit can be fastened to the inverter as follows. For the different initial
situations, please refer to section "Installation of the external Antenna Kit" on page 20.
Fasten antenna extension cable
1. Remove the protective cap from the thread of the antenna on the
inverter housing.
2. Screw the antenna extension cable to the
thread of the antenna on the inverter
housing.
24 BEAMAW-BXX073022
SMA Solar Technology AG