Publicité
Les langues disponibles
Les langues disponibles
2 Control / Operation
2.1
Starting and operating
of the machine
2.2
Adjusting the handle:
VL500 - 55, VL500 - 75,
EDF
2.3
Before wet pick-up
2.4
Wet pick up
2.5
Emptying after wet
pick-up
08
•
Dry cleaner shall always have the sack filter mounted in
the machine. Wet cleaner shall always have the Cartridge
Filter, Wet Filter and the Float System mounted in the ma-
chine during both WET AND DRY operations.
Please also notice that the fill factor at the container may
vary using a sack filter during wet pick-up operations.
•
Clean the water level limiting device regularly and
examine it for signs of damage.
•
This machine shall be stored indoors only.
Check that the electrical switch is switched off (in position 0). Check
that suitable filters are installed in the machine.Then connect the suc-
tion hose into the suction inlet at the machine by pushing the hose for-
ward until it fits firmly in place at the inlet. Then connect the two tubes
with the hose handle, twist the tubes in order to ensure that they are
properly fitted. Attach suitable nozzle to the tube. Choose nozzle de-
pending on what type of material that is to be picked-up. Connect the
plug into a proper electrical outlet. Put the electrical switch into position
1 in order to start the motor. Some variants have two motors/fan units
and two electrical switches - one switch for each motor.
The handle can be adjusted to the suitable working height. Start by
loosening the two locking brackets at each side of the handle. Then
adjust the handle by moving it upwards or downwards until the proper
angle is found. Tighten both locking brackets again to secure the han-
dle.
The machine is equipped with a float system that shuts off the
airflow through the machine when the maximum liquid level is
reached. Never pick up liquid without the float body in place.
To control: Loosen the latch at the front of the motor top .
Then open the motor top. Check that the float basket and float
valve are mounted at the filter plate.
Remounting: Put back the motor top to the container. Then
tighten the latch so that the motor top is properly secured.
Always use a chemical defoamer when picking up water con-
taining foaming detergents. Use a defoamer recommended by
the detergent manufacturer.
During wet suction of foam: On two-motor-machines always
run the machine with only one motor on, in order to avoid ex-
treme foaming and ensure the fill factor of the container.
The machine is equipped with a float body that shuts of the airflow
through the machine when the maximum liquid level is reached. You
will then hear a noticeable change of the sound from the motor and
notice that the suction power decreases. When this occurs, switch the
machine off. Disconnect the machine from the socket.
Before emptying the container, unplug the vacuum cleaner. Always empty and
clean the container and the float system after picking-up liquids. Never pick up
liquid without the float system and filter(s) installed in the machine.
CAUTION
CAUTION
Original instruction
Publicité
