Remote Control Unit - Argo ULTRA Série Notice D'utilisation

REMOTE CONTROL UNIT

DISPLAY
Information is displayed when the remote controller is switched on. If switched off, only the operating mode, the room
temperature and the clock are shown
Operation mode
(
Automatic
Cooling
(
Heating
Dehumidification
Fan
Night mode
SENSOR
A temperature sensor inside the remote control unit
detects the room temperature.
TEMPERATURE SENSOR SELECTOR
Press the I FEEL button to modify the
active setting for room temperature
detection (from remote controller to air
conditioner and viceversa)
TEMPERATURE SETTING BUTTONS
TEMP - (cooler)
Press this button to decrease the set temperature.
TEMP + (warmer)
Press this button to increase the set temperature.
INACTIVE BUTTONS
ON/OFF BUTTON
This button turns the air conditioner ON and OFF.
"SEL TYPE" BUTTON
Press this button in order to:
• set the clock
• set the ON/OFF timer
For details refer to paragraphs "SET-
TING THE HOUR" and "SETTING THE
TIMER".
"FAN " BUTTON
Fan speed is automatically
selected by the microcomputer.
High speed.
Medium speed.
Low speed.
Fan speed
Automatic
Medium speed
High speed
Low speed
TIMER AND PRESENT TIME SETTING
BUTTONS
With these buttons is possible to set the clock and the
timer. For details refer to paragraphs " SETTING THE
HOUR" and "SETTING THE TIMER2.
I FEEL mode is active
(remote controller sen-
sor active)
Displayed when transmit-
ting data
Timer modes
Clock
Room tempe-
rature
Set point tem-
perature
TRANSMITTER
When you press the buttons of the remote control unit,
the mark appears on the display to tran-
smit the setting changes to the receiver in the air condi-
tioner.
"NIGHT" BUTTON
For details, see "NIGHT MODE".
When you press this button in the COOL, HEAT or DRY
mode, the mark appears on the display and
the microcomputer in the remote control unit will adjust
the set temperature to save energy.
"TIMER SEL" BUTTON
Press this button to select the type of timer
to activate.
For details refer to paragraph "SETTING
THE TIMER".
MODE SELECTOR BUTTON
Press this button to modify the air conditioner mode.
(
(automatic)
When this setting is selected, the air conditioner cal-
culates the difference between the thermostat setting
and the room temperature and automatically switches
to the "cool" or "heat" mode.
(
(heating)
The air conditioner makes the room warmer.
(dry)
The air conditioner reduces the humidity in the room.
(cooling)
The air conditioner makes the room cooler.
(fan)
The air conditioner works only as a circulation fan.
(
Not active modality
EG
5