How To Scan - Datalogic QuickScan QS6500 Mode D'emploi

How to Scan

The figure below shows the right and wrong ways to scan a bar
code.
2
1. The linear imager must be pointed at a slight angle to the bar
code so that the light reflected off the bar code can be "seen"
by the linear imager. Do not hold the linear imager perpen-
dicular to the bar code.
2. The targeting beam must cross the entire label. The linear
imager cannot read the bar code data without seeing the
entire label.
Scanning PDF417 Bar Codes (PDF models ONLY)
To read a PDF417 bar code, aim the targeting beam at the top of
the bar code, and in a smooth motion, scan down through the bar
code. You will hear a series of
ticks, followed by a final beep
when the bar code's content has
been completely decoded. You
may need to repeat this process if
the PDF code is hard to read.
2
1
1
2
PDF
QuickScan
®
QS6500