Kärcher SC 3 Deluxe Easy Fix Mode D'emploi page 12

Pressure controller
In case of inadmissibly high pressure in the event of a
fault, a safety valve relieves the pressure into the at-
mosphere.
The fuse prevents the device from overheating. If the
device overheats, the fuse disconnects the device from
the power supply.
Before re-commissioning the device, contact the re-
sponsible KÄRCHER Customer Service.
Description of the unit
The maximum amount of equipment is described in
these operating instructions. Depending on the model
used, there are differences in the scope of delivery (see
packaging).
For the illustrations, refer to the graphics page.
Illustration A
Decalcification cartridge
1
On/Off switch
2
Reduced steam volume
3
Indicator light (red) - replace decalcification car-
4
tridge.
Maximum steam volume
5
Accessory storage area
6
Park bracket for floor nozzle
7
Carrying handle
8
Mains connection cable with mains plug
9
Steam gun
10
Steam lever
11
Unlocking button
12
Child lock
13
Steam hose
14
Spotlight nozzle
15
Round brush
16
** Round brush (large)
17
** Power nozzle
18
Crevice brush
19
Manual nozzle
20
Microfibre cover for manual nozzle
21
Extension tubes (2 x)
22
Unlocking button
23
Floor nozzle
24
Hook and loop fastener
25
Microfibre floor cloth (1 x)
26
** Carpet glider
27
** Microfibre floor cloth (2 x)
28
** SC 3 Deluxe EasyFix Premuium
12
Fuse
ATTENTION
Device damage due to calcification
The decalcification cartridge only works properly if you
adjust the device to the local water hardness before op-
erating it for the first time.
Set the device to the local water hardness.
Set the device to the current water hardness before us-
ing it in an area with a different water hardness (e.g. af-
ter a move)
1. Insert the decalcification cartridge into the opening
and push it so that it is firmly in place.
Illustration B
2. Set the water hardness, see chapter Setting the wa-
ter hardness.
Installing accessories
1. Push the open end of the accessory onto the steam
gun so that the unlocking button on the steam gun
engages.
Illustration C
2. Push the open end of the accessory onto the spot-
light nozzle.
Illustration D
3. Connect the extension tubes to the steam gun.
a Push the 1st extension tube onto the steam gun
so that the unlocking button on the steam gun en-
gages.
The connection pipe is connected.
b Push the 2nd extension tube onto the
1st extension tube.
The connection pipes are connected.
Illustration E
4. Push the accessory and / or the floor nozzle onto the
free end of the extension tube.
Illustration F
The accessory is connected.
Disconnecting accessories
1. Move the child lock back.
The steam lever is locked.
2. Push the unlocking button and pull the parts apart.
Illustration G
The water reservoir can be filled at any time.
ATTENTION
Damage to the device
Unsuitable water can block the nozzles or damage the
water level indicator.
Do not use condensation from the clothes dryer for fill-
ing.
Do not use collected rain water for filling.
Do not use cleaning agents or other additives (e.g.
scents) for filling.
1. Fill the water reservoir with a maximum of 1 l of tap
water.
Illustration H
English
Initial start-up
Installation
Operation
Filling water