Oakley JUDGE II Manuel D'instructions page 9

When the chronograph is reset with button "B," the three chronograph hands return to the zero position. If
the chronograph hands do not align precisely with the zero position (such as after a battery change), use the
p5
following procedure to adjust them.
ADJUSTING THE CHRONOGRAPH HANDS
TO ADJuST THE CHRONOGRAPH HANDS:
1. If the chronograph hands currently show a mea-
sured time, use button "B" to reset them near the
zero position.
Note that the hands must be stopped with button
Button A
"A" to allow button "B" to reset them.
2. Pull the crown out to the second click position (b).
3. Press button "A" and button "B" at the same time
and keep them pressed for at least two seconds.
A B
This puts the chronograph in correction mode.
Button B
4. Press button "A" to adjust the chronograph hand
that measures seconds. Each press moves the
hand one short step; press and hold the button for
continuous movement.
5. Press button "B" then use button "A" to adjust
the chronograph hands that measure minutes and
hours. Each press of button "A" moves the minute
hand one short step; press and hold the button for
continuous movement.
6. Push the crown back down against the case.
JUDGE II INSTRUCTION MANUAL 05
®