Table des Matières
Publicité
ASSEMBLY
STEP 1
VEHICLE PREPARATION:
NOTE: A 1 7/8" hitch ball is required.
Remove the nut from the suspension arm (item 1) on
the vehicle and install the bracket (item 2). Secure
loosely with the original nut. Do the same for the other
side.
If you can not install the brackets on your vehicle,
install the lift strap (item 3) by looping it around the
suspension arm (as shown) on the vehicle.
Tighten the loop firmly.
Do the same for the other side.
Install the brackets or the lift straps
STEP 2
ROTARY BROOM PREPARATION:
Insert the parking stands (item 1) in the stand holders
(item 2).
Secure with a 5/32 x 1" cotter pin (item 3) in the upper
hole (item 4) and a hair pin 2.5 mm (item 5) in the
lower hole (item 6) of each parking stand.
This will allow the broom to rest on the stand.
Install parking stands
7
Publicité
Table des Matières
