Table des Matières
Publicité
DANGER
NEVER OPERATE THE ROTARY BROOM
WITHOUT:
Brush hood
Belt guard
Gear box guard
Extension guard and any other safety protection
devices in place.
CAUTION
Never use the Rotary Broom without the belt
guard.
Push frame installation:
Install the push frame (item 1) to the motor frame
(item 2) by using two cone bearings (item 3), one on
top and the other underneath. Fill the space between
the bearings with grease.
Secure with a seal washer (item 4), the hollow portion
towards the top and a nylon insert lock nut (item 5).
Tighten loosely enough to permit the push frame to
move freely.
Install the link (item 1) on the lever (item 2) and on the
pivot (item 3) using two 1/4" x 1" hex bolts (item 4),
two flat washers (item 5) and two nylon insert lock
nuts.
Tighten loosely enough to permit the parts to move
freely.
ASSEMBLY
8
Install the push frame
Install the link
Publicité
Table des Matières
