Table des Matières
Publicité
ASSEMBLY
STEP 4
INSTALLATION OF THE CONTROL BOX
As shown, choose from the three different ways to
secure the control box support (item 1).
Use two hex bolts 1/4" x 1 1/2" (item 2), the support
brackets (item 4), spacers (item 3) and the flange
nuts.
Insert the control box (item 5) into the support.
Install the control box
Connect the red wire to the positive post and the
black wire to the negative post on the vehicle's
battery.
Secure the wires to the vehicle with the nylon tie
wraps.
NOTE: This wire will stay on the vehicle.
IMPORTANT: The control box is equipped with a red
kill switch in case you need to stop the engine quickly.
NOTE: The emergency button must be pulled out to
start the engine for the broom.
12
Publicité
Table des Matières
