Table des Matières
Publicité
ASSEMBLY
STEP 3
SUBFRAME PREPARATION:
Install the wheel support (item 1) to the subframe
(item 2) using four 7/16" x 1" hex bolts (item 3) and
four flange nuts.
Install the wheel support
Install the assembled turnbuckles (item 1) on the
subframe (item 2).
Secure with two 5/16" x 1" hex bolts (item 3), two 3/8"
flat washers (item 4) and two nylon insert lock nuts.
Position the chains as shown and tighten firmly.
Install the assembled turnbuckles
Remove the 4mm hair pin (item 1) and the pin (item
2) from the broom's push frame.
Install the broom's push frame (item 3) to the
subframe (item 4) with the pin previously removed.
Secure with the 4mm hair pin.
NOTE: The hooked end of the pin must be inserted
into the hole (item 5) to lock it in place.
Install broom to subframe
9
Publicité
Table des Matières
