Cooper Lighting Solutions Portfolio LuxWire Directives D'installation page 2

Installation Instructions – Portfolio LuxWire™ Cylinders
1. Up Down Installation Instructions
1. Cylinder comes fully assembled when received. To
install remove #8-32 nut located in the center of the
2 aircraft cables. The canopy can fall out of the way to
expose the mounting strap. (Figure 1)
Figure 1.
Canopy
Aircraft Cables
2. Connect the mounting strap to the J-Box (supplied by
others) with 2 #8-32 screws. (Figure 2)
Figure 2.
J-Box
#8-32 Screw (2X)
Aircraft Cables
2
Cooper Lighting Solutions
Strap
#8-32 Nut
Strap
#8-32 Nut
IB520143ML Installation instructions
3. For options with the driver in the canopy, there is a
splice cover to provide a barrier to the ceiling and
the driver is attached to the mounting strap. Make
connections to Driver following local code and seeing
the wiring diagrams mentioned in the electrical section.
(Figure 3)
Figure 3.
J-Box
Strap
Canopy
Aircraft Cables
4. For remote driver options, connect remote driver to
J-box following the instruction provided in the kit. Then
connect the remote harness to the aircraft cable using
the orange connectors attached to the ends of each
side.
5. Once wiring is complete, slide the canopy back up to
the ceiling and secure back with the #8-32 nut. Clip zip
ties that is holding the aircraft cable, so the cylinder can
hang free.
6. To adjust height, use cable fittings located on the
cylinder body. Push the fitting to pull the cable through
and be sure to clip the ends so the cable does not
contact any metal components.
7 . Heat shrink is provided to insulate the cables from
the cylinder body. Recommend putting the heat shrink
where the cable contact the cylinder next to cable
fitting.
Splice Cover
Driver
#8-32 Screw (2X)
#8-32 Nut