Cooper Lighting Solutions PORTFOLIO LD4B Instructions D'installation

IB52013222
697916
Installation Instructions – Wiring Drawings LD4C/LD6C
Commercial Recessed LED
Instructions d'installation – Schémas de câblage pour luminaire
à DEL encastré commercial LD4C/LD6C
Instrucciones de instalación – Diagramas de cableado de
luminarios LED empotrados de uso comercial LD4C/LD6C
Risk of Fire, Electrical Shock, Cuts or other Casualty Hazards- Installation and maintenance of this
product must be performed by a qualified electrician. This product must be installed in accordance
with the applicable installation code by a person familiar with the construction and operation of
the product and hazards involved.
Risk of Fire and Electric Shock- Make certain power is OFF before starting installation or
attempting any maintenance. Disconnect power at fuse or circuit breaker.
Risk of Fire- Minimum 90°C supply conductors. For Non-IC fixtures do not install insulation within 3
inches (76 mm) of any part of the luminaire fixture or in a way that may entrap heat.
Risk of Burn- Disconnect power and allow fixture to cool before handling or servicing.
Risk of Personal Injury- Due to sharp edges, handle with care.
Failure to comply with these instructions may result in death, serious bodily injury and property
damage.
DISCLAIMER OF LIABILITY: Eaton assumes no liability for damages or losses of any kind that may arise from the
improper, careless, or negligent installation, handling or use of this product.
IMPORTANT: Read carefully before installing fixture. Retain for future reference.
N ote: 1. Phillips screw driver (6" long minimum); 2. Right angle ratchet and 1/4" socket.
This fixture should be supported by main runners or other structure that is capable of supporting fixture weight
N ote:
of 30 Ibs.
When using electrical equipment, basic safety precautions should always be followed, including the following:
1. This unit is for recessed mounting only. Do not use in hazardous locations nor near gas or electric heaters.
2. Do not use this equipment for other than the intended use.
3. Install only in accordance with National Electrical Code and local regulatory agencies' requirements.
WARNING
SAFETY INSTRUCTIONS
Brand Logo
reversed out of
black
INS # INS # INS #