Massage Variations - Beurer MG 148 Mode D'emploi

If you want to switch on the heat function, press the
heat function switches off.
Press the button to switch the Shiatsu massage belt off again.
The belt can be extended if necessary (see chapter "Belt extension").
Note
• The massage should feel pleasant and relaxing at all times. If the massage is painful or uncomfort-
able, stop the massage or change the contact pressure using the handle.
• Do not use the Shiatsu massage belt for longer than 15 minutes. Longer massages can lead to
over-stimulation of the muscles, creating tension instead of aiding relaxation.
• The Shiatsu massage belt features an automatic switch-off function, which is set to the maximum
operating duration of 15 minutes.
• The Shiatsu massage belt features overheating protection with an automatic switch-off fixture if
the device overheats. In such cases, let the Shiatsu massage belt cool down for 30 minutes before
recommencing use.

Massage variations

Neck massage:
• Place the Shiatsu massage belt on your neck.
• Set the contact pressure to your preferred setting
using the handle.
Back massage (shoulder blade):
• Place the Shiatsu massage belt diagonally around
your left or right shoulder as shown.
• Remove the right handle and feed the straps
through the holder.
• Close the hook and loop fastener.
Belt extension
If you use the device on your shoulder blades or on your lower back, you can extend the Shiatsu massage
belt if required.
button. If you then press the
Back massage (upper back area):
• Place the Shiatsu massage belt around your upper
back area.
• Set the contact pressure to your preferred setting
using the handle.
Back massage (lower back area):
• Place the Shiatsu massage belt around your hips
as shown.
• Remove the handle on the right, feed the straps
through the holder and close the hook and loop
fastener.
13
button again, the