Ir Heat / Ir Heat Massage - Beurer MG 20 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 7
Instructions for use
Use the sliding switch to select the desired function:
Position
0
Off
M
Vibrational massage
W
IR heat for deep results
W + M IR heat massage

IR heat / IR heat massage

Slide the switch to 'W' to heat up the massaging surface. This then begins to light up. After a few minutes, it is
heated up and ready to use.
caution: If the massaging surface is heated up for a long time without coming into contact with the skin, the
temperature could be unpleasantly high for you. Therefore, before using, test the temperature of the massaging
surface with your fingertips. If the surface is too hot, it may be cooled down by briefly switching off the IR heat.
When the massaging surface is at the correct temperature, move the switch to 'W + M'. You may then start the
IR heat massage.
Massage
Without exerting pressure, massage using
slow, circular movements. Keep the skin taut
to achieve optimum results.
Pictures are showing ideal massage direc-
tions.
To intensify the massage, we recommend the following massage heads:
Nubbed head
for all-over massage
recommended massage time:
10–15 mins
front of body
cone head
for specific massage of
muscle parts
3–5 mins
5
back of body
Vacuum head
for gentle massage of
sensitive areas of skin
such as the chest area
3–5 mins

Publicité

Table des Matières
loading

Table des Matières