Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English-04-05
8) During charging, the charger may
become slightly warm. This is
normal.
Symbol
Meaning
V
Volts
Direct Current
n
No Load Speed
0
Revolutions or
.../min
Reciprocation per minutes
Forward Rotation
Reverse Rotation
Drilling Position
WARNING;
Some dust created by power sanding,
sawing, grinding, drilling, and other
construction
activities
contains
chemicals known to the State of
California to cause cancer, birth
defects or other reproductive harm.
Some examples of these chemicals
are:
• Lead from lead-based paints
• Crystalline silica from bricks and
cement
and
other
masonry
products
• Arsenic and chromium from
chemically-treated lumber.
To reduce your exposure to these
chemicals:
work in a well ventilated area, and
work with approved safety equipment,
such as dust masks that are specially
designed to filter out microscopic
particles.
III.
FOR
BATTERY CHARGER
& BATTERY PACK
IMPORTANT SAFETY
lNSTRUCTIONS
1)
SAVE THESE
INSTRUCTIONS
manual contains important safety and
operating
instructions
for
battery
charger EY0005.
2)
Before using battery charger, read all
instructions and cautionary markings on
battery charger, battery pack, and
product using battery pack.
CAUTION
3)
-To reduce the risk
of injury, charge only Panasonic Battery
Pack as shown in last page.
Other types of batteries may burst
causing personal injury and damage.
4)
Do not expose charger to rain or snow.
5)
To reduce risk of damaging the electric
plug and cord, pull by plug rather than
cord when disconnecting charger.
6)
Make sure cord is Iocated so that it will
not be stepped on, tripped over, or
otherwise subjected to damage or
stress.
7)
An extension cord should not be used
unless absolutely necessary.
Use of improper extension cord could
result in a risk of fire and electric shock.
If extension cord must be used, make
sure that:
a.pins on plug of extension cord are the
same number, size and shape as
those of plug on charger.
b.extension cord is properly wired and
in good electrical condition.
c.wire size is large enough for ampere
rating of charger as specified below.
— 4 —
RECOMMENDED MINIMUM AWG SIZE OF
EXTENSION CORDS FOR
BATTERY CHARGERS
AC Input Rating.
Amperes
Equal to or
But less
greater than
than
0
2
8)
Do not operate charger with damaged
cord or plug
replace them immediately.
9)
Do not operate charger if it has received
a sharp blow, been dropped, or otherwise
damaged in any way; take it to a qualified
-This
service personnel.
10)
Do not disassemble charger; take it to a
qualified service personnel when service
or repair is required. Incorrect reassembly
may result in a risk of electric shock or
fire.
11)
To reduce the risk of electric shock,
unplug charger from outlet before
attempting any maintenance or cleaning.
12)
The charger and battery pack are
specifically designed to work together.
Do not attempt to charge any other
cordless tool or battery pack with this
charger.
13)
Do not attempt to charge the battery pack
with any other charger.
14)
Do not attempt to disassemble the
battery pack housing.
15)
Do not store the tool and battery pack in
locations where the temperature may
reach or exceed 50°C (122°F) (such a
metal tool shed, or a car in the summer),
which can lead to deterioration of the
storage battery.
16)
Do not charge battery pack when the
temperature is BELOW 0°C (32°F) or
ABOVE 40°C (104°F).This is very
important in order to maintain optimal
condition of the battery pack.
17)
Do not incinerate the battery pack. It can
explode in a fire.
18)
Avoid dangerous environment. Do not
use charger in damp or wet locations.
19)
The charger is designed to operate on
standard household electrical power only.
Do not attempt to use it on any other
voltage!
20)
Do not abuse cord. Never carry charger
by cord or yank it to disconnect from
outlet. Keep cord away from heat, oil and
AWG Size of Cord
sharp edges.
Length of Cord, Feet
21)
Charge the battery pack in a well
25 50 100 150
ventilated place, do not cover the charger
18 18
18
16
and battery pack with a cloth, etc., while
charging.
22)
Use of an attachment not recommended
may result in a risk of fire, electric shock,
or injury to persons.
23)
Do not short the battery pack. A battery
short can cause a large current flow, over
heating and create the risk of fire or
personal injury.
24)
NOTE: If the supply cord of this
appliance is damaged, it must only be
replaced by a repair shop authorized
by the manufacturer, because special
purpose tools are required.
25)
TO REDUCE THE RISK OF ELECTRIC
SHOCK, THIS APPLIANCE HAS A
POLARIZED PLUG (ONE BLADE IS
WIDER THAN THE OTHER).
This plug will fit in a polarized outlet
only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified
electrician to install the proper outlet.
Do not change the plug in any way.
— 5 —
Publicité
Table des Matières
