Maintenance; Removal And Installation Of The Qwik Lock™ Filter - Workshop WS0400DE0 Mode D'emploi

SP6913-1 Workshop 4 Gallon.qxp_SP6439-3_ES.qxd 7/15/14 6:42 AM Page 13
WARNING: For your own safety,
never connect plug to power source
outlet until all assembly steps are
complete and you have read and
understood the safety and operation
instructions. Do not operate Vac
with any parts damaged or missing.
Remove Lid Assembly:
1. Grasp the drum latches on both the
right and left side of the power head.
Slowly pull the drum latches away
from the drum. Lift the Lid and blower
assembly off the drum. Place the lid
and blower assembly of the vac upside
down.
Removal and Installation
of the Qwik Lock™ Filter
Filter Removal:
1. Hold the Filter tabs of the Qwik Lock™
Filter in each hand.
2. With one thumb on the Qwik Lock™
stud, which protrudes through the
integrated Filter plate, lift up on the
Filter tabs while pushing down on the
stud.
3. This action will cause the Filter to
release from the Filter cage. Slide
Filter off cage.
Filter Installation:
1. Carefully slide the Qwik Lock™ Filter
over the Filter cage and press down
on the outside edge of the Filter until
the rubber gasket on the bottom of the
Filter seats securely around the base
of the Filter cage and against the lid.
2. Align the small center hole in the top
of the Filter over the Qwik Lock™ stud
on the Filter cage. Press firmly on top
of the Filter near the stud to allow the
Filter to snap over the ball on the end
of the stud. The Filter is now attached.
All manuals and user guides at all-guides.com

MAINTENANCE

Lid
Assembly
Integrated Filter
Plate with Center
Hole
Filter
Tabs (2)
Lid
Assembly
NOTE: Failure to properly seat the bottom
gasket could result in debris bypassing
the Filter.
without Filter cage and float, as they
prevent liquid from entering the
impeller and damaging the motor.
13
PUSH
DOWN
Qwik Lock™
Stud
WARNING: Do not operate
Drum
Latch (2)
Pull
Out
And
Lift Up
PULL
UP
Rubber
Gasket at
Bottom of
Filter
(cutaway view)
Filter Cage