Detachable Blower (Removal And Installation) - Workshop WS0400DE0 Mode D'emploi

SP6913-1 Workshop 4 Gallon.qxp_SP6439-3_ES.qxd 7/15/14 6:42 AM Page 7
DETACHABLE BLOWER
1. To remove the detachable blower from
the lid assembly, press down on the
detachable blower latch under the
detachable blower handle and lift the
blower off the lid of the Vac.
2. To replace the detachable blower onto
the lid assembly, position detachable
blower above the indented area of the
lid assembly. Rotate the detachable
blower down until the travel of the unit
stops.
3. Lightly press down on the carry handle
of the detachable blower until you hear
the "snap" of the detachable blower
latch engaging the detachable blower.
The detachable blower is now latched
to the lid assembly.
4. Your new Wet/Dry Vac is ready for
use. With the Wet/Dry Vac completely
assembled and ready for use, insert
the push button end of the locking
hose into the inlet of the Vac. The
hose should snap into place. To
remove the hose from the Vac, press
the release button in the hose
assembly and pull the hose out of the
Vac inlet, as shown.
All manuals and user guides at all-guides.com
Detachable
Blower Carry
Handle
Detachable
Blower
Latch
Detachable
Blower
Lid Assembly
Indented Area (2)
Detachable
Blower Carry
Handle
Detachable
Blower
Latch
Release
Button
7
(Removal and Installation)
Press Then
Push or Pull
Vac Inlet
Detachable
Blower
Detachable
Blower