Detachable Blower Intake; Cleaning Vac Filter - Workshop WS0400DE0 Mode D'emploi

SP6913-1 Workshop 4 Gallon.qxp_SP6439-3_ES.qxd 7/15/14 6:42 AM Page 14
MAINTENANCE (continued)

Detachable Blower Intake

WARNING: To reduce the risk of
injury from accidental starting,
unplug power cord before changing
or cleaning filter or foam pad.
After using the detachable blower of your
Wet/Dry Vac, examine the bottom of the
blower for dust and debris. Check to see
if the intake to the blower has debris
stuck to the plastic vents and foam pad.
To clean the foam pad under the intake
shield of the detachable blower:
1. Remove the three screws holding the
intake shield.
2. Lift the intake shield off and set aside.
3. Lift the foam pad away from the
detachable blower.
4. Remove the foam pad and clean in
warm soapy water or brush debris
away. Allow foam pad to dry.
5. Examine foam pad for reuse. If you
need to replace it, check the service
part section of this manual.
6. Replace foam pad by reversing Steps
1 thru 4.
7. Reinstall intake shield and 3 screws.
The unit is ready for use.
All manuals and user guides at all-guides.com

Cleaning Vac Filter

NOTE: The filter is made of high quality
paper designed to stop very small
particles of dust. The filter can be used
for dry pick up or small amounts of liquid.
Handle the filter carefully when removing
to clean or installing it. Creases in the
filter pleats may occur from installation
but will not affect the performance of the
filter. Your filter should be cleaned often to
maintain peak Vac performance. Be sure
to dry the filter before storing or picking
up dry debris.
14
Foam Pad
Intake
Shield
Screws (3)