Artromot ® -S3 Description; Description Of The Device Components - Ormed ARTROMOT-S3 Mode D'emploi

2. ARTROMOT
The motorized CPM device supports
the following movements of the shoul-
der joint:
Adduction/abduction
Internal/external
rotation
Elevation (flexion)
with elbow bent between
Horizontal adduction/
abduction
(manual adjustment only)
It can be reconfigured for use on either
side.
Note !
To allow the current position of the
CPM device to be clearly indicated,
the internal rotation values on the
display and throughout this document
are identified with "-".
These are some of the outstanding
ARTROMOT ® -S3 features:
- anatomically correct setup
- physiological movements
- maximum possible ranges of motion
- programming unit for precise adjust-
ment of patient-specific therapy
values
- chip card for storage of the pro-
grammed therapy parameters
- easy transport
Biocompatibility
Those parts of the ARTROMOT
device that come into contact with the
patient when the device is used as
intended, are designed to fulfil the
biocompatibility requirements of the
applicable standards.
2.1 Description of the device
components
Note:
Please fold out page 3!
® -S3 description
0° - 30° - 175°
90° - 0° - 90°
0° - 30° - 175°
60° and 90°
0° -120°
® -S3
46
1. Programming unit
2. Patient chip card
3. Compartment for storage of
programming unit
4. Armrest for healthy arm
5. Wheels
6. Connection for power cord
7. Power switch (ON/OFF)
8. Instrument fuse
9. Connection for motion element
10. Thumbscrew for adjustment of the
backrest angle
11. Folds down the backrest (transport
position)
12. Adjustment for horizontal adduc-
tion/abduction
13. Holding tube for height adjusment
14. Locking screw for height
adjustment
15. Insertion tube for height adjustment
16. Motor A
17. Holding tube for length adjustment
(upper arm)
18. Clamping lever for length adjust-
ment (upper arm)
19. Insertion tube for length adjustment
(upper arm)
20. Locking screw for elbow range
21. Motor B
22. Elbow support
23. Forearm support
24. Strap for forearm restraint
25. Holding tube for length adjustment
(forearm)
26. Clamping lever for length adjust-
ment (forearm)
27. Insertion tube for length adjustment
(forearm)
28. Locking screw for swivel
mechanism
29. Handle
30. Headrest adjustment
31. Height adjustment for shoulder
restraint 1
32. Height adjustment for shoulder
restraint 1
33. Ball joint for headrest
34. Locking pin
Subject to technical modifications
(06/2007)
1
Only with ARTROMOT
1
1
®
-S3 comfort