Steelcase Ology Mode D'emploi page 4

®
4.
Remove inner back from case assembly
by pulling off velcro pads (4a).
Install two (2) support brackets as shown
using three (3) Tapping Screws, TRH,
SERR, 10-12 x .625 per bracket provided in
installation kit (4b).
Proud top offset from front edge of top by
7/8" (4c). Flush tops are aligned to the front
of the unit. Secure unit to bottom side of top
by installing six (6) Tapping Screws, TRH,
SERR, 10-12 x .625 provided in
kit (4d).
PROUD TOP OFFSET
FROM FRONT EDGE
OF TOP BY 7/8"
FRONT EDGE OF TOP
installation
4c
INNER BACK
4a
4d
SUPPORT BRACKET
TAPPING SCREW -
TRH, SERR, 10-12 X .625
4b
TAPPING SCREW -
TRH, SERR, 10-12 X .625
BOTTOM SIDE
OF TOP
Page 4 of 27
82435 Rev A