Installation - ASCOM Arte 20 Mode D'emploi

Installation

Contents of packaging
Telephone Handset
1 2 3
END ABC DEF GHI
4 5 6
JKL MNO PQR
7 8 9
STU VWX YZ•
0
0...9
Connecting handset and telephone
After you have unpacked the telephone, connect
the handset first, by inserting the longer straight
end of the spiral connecting cable into the small
socket on the base of the telephone. By gently
pulling, check that the cable connector is correctly
in place. Insert the other end of the cable into the
handset.
Now connect the telephone by inserting the
connector on the telephone connecting cable into
the large socket on the base of the telephone. By
gently pulling, check that the cable connector is
correctly in place. Put the cable through the
provided tension relief channel. Insert the other
end of the cable into the telephone connection
socket.
If you are using your telephone as a desktop
model, insert the two support feet into the top of
the telephone base.
Labelling the programmable key
Below the programmable key, note down the names of the two stored numbers onto the
removable identification label, on the last page of this booklet. Finally, cover the label
using the transparent cover.
20317509en_bat_a0
Telephone
connecting cable
Feet
Transparent cover
Pyramid for wall mounting
Handset
Connecting cable
Brief operating
instructions
Redialling
Absent/Present
Loudspeaker on/off (Double click louder)
Initiate inquiry call
Cancel inquiry call
END
Brokering in inquiry call (during call)
Transfer call
3
Initiate conference (during inquiry call)
GHI
Initiate call back (with busy or ringing tone)
Answer call back
Saving a number in the private card file
• Enter the number
• Press the digit key, e.g., 6 , of the
PQR
corresponding card number until the
acknowledgement signal is heard
Terminate/Reseize (during dialling or call)
END
[1]
Bedienungsanleitung
Mode d'emploi
Istruzioni per l'uso
Operating instructions
Operating
instructions
9