NOCO Genius GENPRO Serie Mode D'emploi page 7

Begin Charging.
1.) Verify the voltage and chemistry of the battery.
2.) Confirm that you have connected the battery clamps or eyelet terminal connectors properly and the AC power plug is plugged into an electrical outlet.
3.) [First time use] The charger will begin in Standby mode, indicated by an orange LED. In Standby, the charger is not providing any power.
4.) Press the mode button to toggle to the appropriate charge mode (press and hold for three seconds to enter an advanced charge mode) for the voltage and
chemistry of your battery.
5.) The mode LED will illuminate the selected charge mode and the Charge LEDs will illuminate (depending on the health of the battery) indicating the charging
process has started.
6.) The charger can now be left connected to the battery at all times to provide maintenance charging.
Auto-Memory:
The charger has built in auto-memory and will return to the last charge mode when connected. To change modes after the first use, press the mode
button.
Charging Times.
Charging Times.
The estimated time to charge a battery is shown below. The size of
the battery (Ah) and its depth of discharge (DOD) greatly affect its
charging time. The charge time is based on an average depth of
discharge to a fully charged battery and is for reference purposes only.
Actual data may differ due to battery conditions. The time to charge
a normally discharged battery is based on a 50% DOD. Temperature
will also impact charging times. The GENPRO Series features thermal
compensation that automatically adjusts charging profiles to maximize
charging performance.
Battery Size Approximate Time to Charge In Hours
Ah (Amp hour)
20
40
80
100
230
12V
1.5
3.0
6.0
7.0
17.3