Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Lay the cabling sheath behind the engine.
34
Disconnect the light purple cable (31) from the starter relay
(32) and connect it to the brown cable (33) of the interface
cabling, then fasten the blue interface cable (34) to the
32
starter relay contact.
Fasten the cables in place replacing any removed cable
binders.
31
33
Tool Bag «G»
35
From the lever side (41), connect the brown cable (33) to
contact «C» on the microswitch (35) and the blue cable (34)
to the «NO» contact, then cover the «NC» contact with spe-
33
cific rubber insulating tape.
41
34
Fit the microswitch (35) using the screws supplied and
adjust the position so that it is correctly enabled when the
release lever is activated, and there is at least 1 mm of re-
sidual travel on the micro-switch wheel when the lever (41)
is in position «B».
35
WARNING! - Great care must be taken when ad-
justing the microswitch as it is a safety device that
prevents the engine from starting with the move-
37
41
ment of the attachment engaged.
39
Lay the electric sheath (36) and the engagement cable (38)
36
so that both remain inside the lifting lever (37).
38
Fasten the sheath (36) and the engagement cable (38) to
the lifting lever using the special binders (39) suitably dis-
tanced as seen in the diagram.
Position the electric cable sheath (36) behind the engine.
Check that the movement of the lever does not cause pull-
ing or folding of the sheath or the cable, especially on the
39
front side of the machine, and that the cable does not inter-
39
fere with the steering movement.
39
36
Fasten the electric sheath (36) in place using the binders
(39) as seen in the diagram.
39
39
31
Publicité
Table des Matières
