ST 1503 Manuel D'installation page 25

▶▶ With standard muffler:
Tool Bag «B»
Loosen the nuts that fasten the engine exhaust collec-
tors and the two screws (13) so as to obtain good mo-
bility of the support bracket (14) and facilitate the next
operations.
Assemble the exhaust pipe (15) introducing the tail
pipe into the opening of the right bracket on the lifting
module, and fasten in place using:
– 2 upper screws (16), with the relative washers (17);
– 1 lower screw (18) with relative washer (19), using
the lowest bracket hole.
Check the exhaust pipe (15) is correctly fitted, tighten
the fastening nuts on the exhaust collectors and the
two screws (13) to fasten the support bracket (14) in
the correct position obtained in the previous phase.
Remove the exhaust pipe (15) using the relative nuts
and bolts (16 - 17 - 18 - 19).
Apply the muffler guard (20) and the exhaust pipe (15)
simultaneously and fasten the ensemble using the pre-
viously removed nuts and bolts
.
▶▶ With Stiga Style muffler:
Assemble the exhaust pipe (21) introducing the tail
pipe into the opening of the right bracket on the lifting
module, and fasten in place using the sleeve (22).
Tool Bag «D»
Pre-assemble the upper guard (23) using the two special
screws (24) with washers (24a), and fasten using the crown
fixation pins (24b).
Fit the top guard (23) fastening it in place using the two spe-
cial screws (24) and the self-tapping screws (25).
Fit the right (26) and left side grids, fastening them in
place using the self-tapping screws (27).
24 24a 24b
24 24a 24b
23
24
24a 24b
14 13
13
18
19
18
19
21
27
27
24
26
17
16
15
17
16
20
22
23 25 24
25