General Information; Preparing The Machine - ST 1503 Manuel D'installation

Multi connect system (interface /power take off(pto)
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GENERAL INFORMATION

The information contained in this manual are exclusively
destined for use by Support Centres and expert profes-
sional operators who are capable of performing the opera-
tions described using the required tools and equipment, so
as to safeguard the performance and safety of the machine.
The interface described in these instructions is a connection ele-
ment between the machine and a front attachment, designed to
implement the various ways of using the machine.
The interface can be applied to the following models:
NJ 92-102 (in the various versions)
TC-TX 102-122 (in the various versions)
SD 108-118 (in the various versions)
with slight differences, indicated in the instructions when these
differences refer to the use of the attachments contained in the kit
or procedural aspects.

1. PREPARING THE MACHINE

Disconnect the connector (1) and remove the front hood.
Remove the clamp (2).
Remove the muffler guard (3) and remove the front bumper
(4).
▶ for NJ: remove the left side guard (5), eliminate the
lower appendix and make a 30 x 70 mm discharge in the
plastic as indicated in the diagram.
▶ for TC - TS - TX - SD: remove the left (5a) and right
(6) side guards, and make a 50 x 70 mm discharge in
the plastic of each of them, as indicated in the diagram.
NJ
70
The interface can consist of two modules:
● lifting module, for attachments that do not require a power take
off;
● power take off (Transmission KIT), for attachments fitted with
moving parts;
The module power take off can be applied simultaneously to the
assembly of lifting module, or at different moments in time.
If module power take off is used for applications on NJ 92 (in
the various versions) it is necessary to use the steering rod, code
299900800/0.
The Manufacturer is not liable for any damage or injuries caused by
interventions made by other individuals at inadequate facilities or per-
formed in a manner which differs from these instructions.
TC - TX - SD
5
2
70
1
3
4
5a
6
70
23

Publicité

Table des Matières
loading

Table des Matières