Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
● Refit the front hood.
Check that the hood opens completely, without interfering
with the lifting system; this could occur in certain cases and
requires the creation of an outlet in the lower left region of
the hood.
To eliminate interference in hoods which have already been
prearranged, simply use the tracing inside the hood itself;
on the contrary, follow the indications provided in the draw-
ing.
3. PRE-ASSEMBLY OF THE PTO ON THE LIFTING
MODULE
NOTE - The descriptions that follow presume that the PTO
components have been fitted on the lifting module on the
work bench, before the latter is applied to the machine.
If the lifting module is already assembled on the machine,
it is recommended to remove it following the instructions
provided in Chap. 2 in reverse order.
NOTE - The required fittings are contained in the bags
marked with a letter. (
Tool Bag «E» - «N»
Fit the support with the return shaft (1) on the lower section
of the lifting module frame (2), making sure that the external
bearing ring is in contact with the frame (2).
Fix the support (1) using the screws (3) and toothed locking
washers (4), apply a tightening torque of 20-25 Nm.
Fit the disc tab (5) onto the end of the shaft and fit the upper
pulley (6 - black) fastening it in place with the screw (7), the
washer (8) and the grower washer (8a) with a tightening
torque of 20-25 Nm.
Likewise, fit the disc tab (5a) and the lower pulley (6a) fix-
ing it with the screw (7a), the washer (8b) and the grower
washer (8c) with a tightening torque of 20-25 Nm.
148
«E» - «F» - «G» - «H» - «N»)
Use a suitable tool to perform this operation, making sure all
cutting burr is removed and any sharp edges are smoothed off
to prevent cuts in cases of accidental contact.
● Reconnect the headlamp connector and reinstate the elec-
tric cable fastener clamp.
● Reassemble the left and right side guards.
● Apply the attachment to the interface, check that it
rises and lowers correctly and that the lock system
works properly in a raised position.
8 - 8b
35
53
3 4
2
1
7
8a
8
6
5
2
5a
6a
8b
8c
7a
27
Publicité
Table des Matières
