Flight Operation; Description Of Control & Functions - Carson X4 Quadcopter 270 Backflip Manuel D'instructions

FLIgHt operatIon

trimming the quadcopter
Already shortly before the quadcopter takes off, you can recognize
whether it wants to turn or glide in a particular direction. Correct
the deviations from the vertical ascent with the trim knob of the
turn function.
Model slips (drifts) or tilts to the right:
• Reduce the speed and push the trim slider of the roll-function of
the right remote control lever stepwise to the left.
• Push the gas-lever forward again and check whether the correc-
tion was sufficient, if necessary shift the trim further to the left.
• Repeat the process until the quadcopter no longer shows a
tendency to drift to the right.
Model slips (drifts) forward:
• Reduce the speed and push the trim slider of the nick function
on the right remote control lever stepwise backwards.
• Push the pitch lever forward again and check whether this was
sufficient for correction, if necessary shift the trim further to the
left.
• Repeat the process until the quadcopter no longer shows a
tendency to drift forwards.
DeScrIptIon oF controL & FunctIonS
GB // 26
Model slips (drifts) or
tilts to the left:
• Proceed as described above,
but push the trim slider of the
tail function stepwise to the right.
Model slips (drifts)
backwards:
• Proceed as described above,
but push the trim slider of the
nick function stepwise forward.
Calibration function: If the quadcopter always drifts to one side
after launching, place the model on a horizontal surface (table, floor)
and reconnect the 2.4 GHz signal.
Once it is switched on move both control levers to the bottom switch
(illustration) until the LEDs flash. Now switch the transmitter to „off"
and again „on".
The calibration procedure is now complete.