Repair Service - IKRA Mogatec IELM 1000 I Manuel D'utilisation

tools such as a brush or broom.
To ensure that it can collect the grass correctly the grass
bag and in particular the net must be cleaned from the
inside after use.
Only attach the grass bag after switching off the motor
and the cutting tool has reached a standstill. Raise the
discharge flap (2) with one hand and, holding the grass
bag (1) by its handle in your other hand, attach it from
the top.
Blade maintenance
• Regularly remove grass and dirt from the blade.
• At the beginning of the gardening season, carefully
examine the condition of the blade.
• If the blade is very blunt, sharpen or replace the blade.
• If the blade is damaged or worn, fit a new blade.
• If the blade is slipping, tighten the blade by wrench.
(see fig. 8)
Warning! Observe the following precautions:
• Disconnect the mower from the mains and wait until
the blade has stopped rotating before proceeding.
• Be careful not to cut yourself. Use heavy-duty gloves
or a cloth to grip the blade.
• Only use the specified replacement blade.
To replace the blade
• Turn the mower onto its side.
• Loosen the fastening screw (Fig. 8).
• Remove the blade and replace with a new one.
• When fitting the blade, make sure it is installed in the
right direction. The blade's air vanes must jut into the
motor compartment.
• Then retighten the fastening screw. The tightening
torque should be approx. 25 Nm.
MAINTENANCE
Warning: Stop the mower and remove the
plug from the power supply before remove the
grass box.
Note: To ensure long and reliable service, carry out the
following maintenance regularly:
Check for obvious defects such as a loose, dislodged or
a damaged blade, loose fittings, and worn or damaged
components.
Check that the covers and guards are all undamaged and
are correctly attached to mower.
Carry out any necessary maintenance or repairs before
operating mower.
If the mower should happen to fail despite regular main-
tenance, please call our service helpline for advice.
Warning: Make sure to turn to professional
maintenance agency when replacing the blade.
Warning: Never carry out any assembly opera-
tions or adjustments with the power connected
to the mower. Always ensure that the power but-
GB | Instruction Manual
STORAGE
Clean the exterior of the machine thoroughly using a soft
brush and cloth. Do not use water, solvents or polishes.
Remove all grass and debris, especially from the venti-
lation slots.
Turn the machine on its side and clean the blade area. If
grass cuttings are compacted in the blade area, remove
with a wooden or plastic implement.
Store the machine in a dry place. Do not place other ob-
jects on top of the machine.
Release the knob module and fold the upper handles.
Ensure cables are not stuck or entangled when folding or
unfolding top handles. Do not drop the handles.
When using a vehicle to transport the machine, position
it so that it can cause no danger to persons and fasten
it firmly.

REPAIR SERVICE

Attention! Electrical repairs may only be carried out by a
skilled electrician or a customer service workshop!
If you send the machine to us for repair, please describe
the fault.
WARRANTY
For this electric tool, the company provides the end user
- independently from the retailer's obligations resulting
from the purchasing contract - with the following war-
ranties:
The warranty period is 24 months beginning from the
hand-over of the device which has to be proved by the
original purchasing document. For commercial use and
use for rent, the warranty period is reduced to 12 months.
Wearing parts and defects caused by the use of non
fitting accessories, repair with parts that are not original
parts of the manufacturer, use of force, strokes and
breaking as well as mischievous overloading of the motor
are excluded from this warranty. Warranty replacement
does only include defective parts, not complete devices.
Warranty repair shall exclusively be carried out by au-
thorized service partners or by the company's customer
service. In the case of any intervention of not authorized
personnel, the warranty will be held void.
All postage or delivery costs as well as any other subse-
quent expenses will be borne by the customer.
GB-7
ton is in the off position and that the power plug
is disconnected from the supply.