Operating Temperature Range - Razor Power A 2 Mode D'emploi

EN
• Do not attempt or do stunts or tricks on the product. The product is not strong enough to withstand misuse and abuse such as jumping,
curb grinding or any other type of stunts. Racing, stunt riding, or other maneuvers also increase the risk of loss of control, or may cause
uncontrolled rider actions or reactions. All of these could result in serious injury or possibly death.
• Never allow more than one person at a time to ride this product.
• Do not allow hands, feet, hair, body parts, clothing, or similar articles to come in contact with moving parts or wheels.
• Never use headphones or a cell phone when riding.
• Never hitch a ride with a vehicle.
Proper Riding Equipment, Clothes, Shoes
• Always wear proper protective equipment, such as an approved safety helmet (with chin strap securely buckled), elbow pads and
kneepads. A helmet may be legally required by local law or regulation in your area. In addition, a long-sleeved shirt, long pants, and gloves
are recommended.
• Always wear athletic shoes (lace-up shoes with rubber soles), never ride barefoot or in sandals, and keep shoelaces tied and away from the
wheels, motor and drive system.
Using the Charger
• Never modify the electric system. Alteration could cause a fire.
• Use ONLY the Power A2 charger.
• Initial charge time: 8 hours.
• Recharge time: up to 6 hours, even if the light turns green. Recommended maximum charging time is 24 hours.
• Turn off after each ride. The battery may be unable to recharge if left "ON" without use.
• Do NOT charge at or below freezing (0º C).
• Do not allow charger or battery pack to overheat. If they seem warm, allow to cool down. Charge only at room temperature.
• Do not place product or charger in the sun or warm environment. Keep at normal room temperature.
• Battery pack should not be disassembled, crushed, punctured, opened or otherwise mutilated.
• The charger supplied with this product should be regularly examined for damage to the cord, plug, enclosure and other parts.
• In the event of such damage, the product must not be charged until the charger has been repaired or replaced.
• The charger is not a toy. Charger should only be operated by an adult.
• Do not operate charger near flammable materials or an open flame.
• Unplug charger and disconnect from the product when not in use.
• Do not exceed charging time.
• Always disconnect product from charger prior to wiping it down or cleaning with a damp cloth.
Model
Power A 2
Maintenance
• Always inspect product before riding and regularly maintain it. Replace worn or damaged parts immediately.
• Check that the steering system is correctly adjusted and that all connection components are firmly secured and not broken.
• Check brake for proper function. When you step on the rear-fender brake with your foot, brake should provide positive braking action.
• Under normal circumstances and conditions, the wheels and bearings are maintenance free.
• Regularly check that the various screwed parts are tight.
• No modifications can be made that can impair safety.
• Wipe with a damp cloth to remove dirt.
• Use only authorized Razor replacement parts.
Limited Warranty:
This Limited Warranty is the only warranty for this product. There is no other express or implied warranty.
The manufacturer warranties this product to be free of manufacturing defects for a period of 90 days from date of purchase.
This Limited Warranty will be void if the product is ever:
• used in a manner other than for recreation or transportation;
• modified in any way;
• rented.
Failure to use common sense and heed the above warnings further increases risk of serious injury. Use at your own risk and with
appropriate and serious attention to safe operation. Use caution.
Li-ion
CONTAINS LITHIUM-ION BATTERY PACK. BATTERIES MUST BE RECYCLED.
UL 2271 COMPLIANT.
Li-ion
PowerA2_MAN_24L_CAN_190701_UL.indd 6
Voltage Capacity
(Nominal) Vdc (Nominal) Ah
21.6 2.15
Charge
Temperature Range
0° to 45°C
32° to 113°F
6
Operating
Temperature Range
-20° to 60°C
-4° to 140°F
7/1/19 5:09 PM