Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
How to Use Adjustable Slicing Disc
Laceration Hazard.
w WARNING
• Handle disc carefully; it is very sharp. Make sure unit is
switched to OFF ( ) and is unplugged.
• Always use food pusher to feed food into the chute. Never
push food through chute with hands or other objects.
1. Place bowl on base with handle
facing to the right. Adjust disc to
desired thickness by turning the
adjustment post. There are
6 adjustment positions, ranging from
1 mm to 6 mm (1/32" to 1/4").
Carefully place adjustable slicing disc
straight down onto motor shaft.
2. Place lid on bowl. Raise locking arm
up and over bowl and snap into
place. Plug into outlet.
3. Place food into food chute and use
food pusher. Do not fill bowl above
MAX FILL line.
4. Select Low (LO) speed by moving
left switch down. NOTE: This food
processor will start in the speed it
was last used.
5. Move ON ( ) switch up to turn on food processor or press
switch down to PULSE for instant on and off control.
6. When finished, switch to OFF ( ) and unplug. Push locking
arm back to unlock lid and lower arm onto counter.
7. Always remove lid before removing bowl to avoid possible
damage to the appliance. Carefully remove disc from motor
shaft using the finger holes. Pour out food.
NOTES:
• Check to make sure no other blades are in the bottom of the
work bowl.
• Bowl scraper cannot be used with adjustable slicing blade
disc.
• For smaller, thinner foods, like carrots, cut in half and load
pieces side by side in the chute in an upright position to
prevent the food from falling over. This will result in more
uniform slices.
• LO speed is recommended for slicing and shredding.
7
Publicité
Table des Matières
