Publicité
5
INSTALL THE PIVOT MOUNT.
Align the pivot mount from
the LockNLoad Platform with
the bracket. Then thread two
M6 x 16 mm capscrews from
the platform hardware and
tighten to 3.5 Nm using the
torque wrench.
NOTE: The pivot mount assembly
will still have movement after
tightening the screws.
NOTE: Always use the center mounting
point unless directed otherwise by your
vehicle specific kit and or fit notes.
6
OPEN THE COVERS.
Open the SkyLine™ covers.
ATTACH THE TOWER AND PIVOT MOUNT
7
ASSEMBLIES TO YOUR LANDING PADS.
First lay a towel over the roof to protect it. Place the SkyLine™ tower and pivot
mount assemblies onto your Landing Pads as shown. Be sure the SkyLine towers
are fully seated and then close the SkyLine covers. Note: The second pair of pivot
mount assemblies are for reference only. Additional adapters are sold separately.
Continue with your LockNLoad Platform instructions to complete your Platform installation.
Instruction #1036004B - Page 5 of 9
NOTE: Alternate mounting points to allow an increase
in each platform's crossbar spread compatibility.
3.5 Nm
3.5 Nm
2X
2X
2X
2X
Publicité
