Publicité
6
INSTALL THE PIVOT MOUNTS.
Align the pivot mount from the
LockNLoad Platform with the bracket.
Then thread two M6 x 16 mm capscrews
from the platform hardware and tighten
to 3.5 Nm using the torque wrench.
NOTE: The pivot mount assembly
will still have movement after
tightening the screws.
NOTE: Always use the center mounting
point unless directed otherwise by your
vehicle specific kit and or fit notes.
ATTACH THE TOWER AND PIVOT MOUNT ASSEMBLIES
7
TO THE VEHICLE'S RAISED SIDERAILS.
Note: Second pair of pivot mount assemblies are for reference only. Additional adapters sold separately.
Route the straps
around your
siderails and
re-engage the
straps then
tighten the
bolts until the
assemblies are
stable on the
rails but DO
NOT TIGHTEN
them completely.
Continue with your LockNLoad Platform instructions to complete your Platform installation.
Instruction #1036004B - Page 3 of 9
NOTE: Alternate mounting points to allow an increase
in each platform's crossbar spread compatibility.
Place the Timberline™ tower and pivot mount
assemblies on top of the rail, ensuring that the
hole on the underside of the assembly is positioned
directly on top of the rail. Check that the strap can
pass underneath the rail and re-engage with the
cradle. If not, back off bolt shown in Step 3 further.
3.5 Nm
"Click!"
"Click!"
"Click!"
2X
2X
2X
2X
Publicité
