Publicité
SKYLINE™ INSTALLATION • SKYLINE INSTALLATION • SKYLINE INSTALACIÓN
1
OPEN COVERS.
Squeeze and pull to
open the covers.
4
INSTALL THE BRACKET AND PLATES.
IF NECESSARY ADJUST THE PITCH OF YOUR SKYLINE TOWER.
Assess your vehicle beforehand and set the tower's pitch to match your vehicle's
A. Install the bracket from your LockNLoad
Platform, the plate, and nut insert as
shown. Set the tower pitch. Tighten to
3.5 Nm using the torque wrench.
B. Then tighten the adjustment screws
to 3.5 Nm using the torque wrench.
B
"Click"
"Click"
"Click"
Instruction #1036004B - Page 4 of 9
BACK OUT
2
ADJUSTMENT SCREW.
Use the 4 mm torque
wrench supplied with
your SkyLine™ towers to
loosen the adjustment
2X
2X
screw about 8 turns.
Vehicles with curved rooflines or siderails may require more pitch adjustment.
roofline. Adjust the bracket so it will be level once installed on your vehicle.
3.5 Nm
8X
2X
2X
A
3
INSTALL THE ADAPTERS.
Snap the
adapters
into place.
"Snap"
A
"Click"
"Click"
"Click"
3.5 Nm
2X
2X
2X
2X
Publicité
